BBS RS style illustration
Illustration of the BBS RS design; no photo of this exact part number.

BBS RS series

BBS RS312

  • Size13x17"
  • PCD5x130
  • OffsetET-22
  • Centre bore71.6 mm
  • Lip5"
  • Barrel7.5"

This page covers the BBS RS312, one wheel from the RS range, built from a cast mesh centre bolted between separate inner and outer rim halves. It is a 17-inch wheel, 13 inches wide and is listed for Porsche C62 HA.

On the BBS RS312, the 5x130 PCD is the one used by Porsche and some Mercedes-Benz; the 71.6 mm centre bore matches Porsche hubs.

The BBS RS312 has a low ET-22 offset, so the face sits well outboard; that is typical of older rear-drive cars and of wheels meant to fill the arches. A 13-inch rim normally takes tyres from about 335 to 375 mm wide.

At 17 inches, the BBS RS312 also has to clear the brake calipers of the car it goes on; that matters most where the brakes have been upgraded.

The BBS RS312 is a multi-piece wheel, so the lip and barrel are separate parts: lip 5", barrel 7.5". You need these figures to order replacement rim halves or rebuild the wheel to a new width.

More on where the BBS RS312 came from and how it is built is on the BBS RS page.

Specifications

BBS RS312 specifications
Model / partPCDDiameter (in)Width (in)Offset (ET)Centre bore (mm)LipBarrelFitmentNotes
BBS RS3125x1301713-2271.65"7.5"Porsche C62 HA—

Size in inches, offset and bore in mm. How to read these figures.

All BBS RS models