
BBS RS series
BBS RS355
- Size8x17"
- PCD4x114.3
- OffsetET38
- Lip1"
- Barrel6.5"
This page covers the BBS RS355, one wheel from the RS, a three-piece cross-spoke mesh wheel first sold in the 1980s. It is a 17-inch wheel, 8 inches wide.
The 4x114.3 bolt pattern of the BBS RS355 is the one used by older Nissan and Mitsubishi.
ET38 is a high offset for the BBS RS355, so it tucks well inside the arch, as front-drive and most modern cars need. Tyre widths of roughly 205-245 mm are the usual match for an 8-inch rim.
At 17 inches, the BBS RS355 also has to clear the brake calipers of the car it goes on; that matters most where the brakes have been upgraded.
BBS RS355 multi-piece build: lip 1", barrel 6.5". You need these figures to order replacement rim halves or rebuild the wheel to a new width.
The centre bore and fitment of the BBS RS355 are not recorded here; the back of the centre usually carries the offset and part number, so check the wheel itself.
More on where the BBS RS355 came from and how it is built is on the BBS RS page.
Specifications
| Model / part | PCD | Diameter (in) | Width (in) | Offset (ET) | Centre bore (mm) | Lip | Barrel | Fitment | Notes |
|---|---|---|---|---|---|---|---|---|---|
| BBS RS355 | 4x114.3 | 17 | 8 | 38 | — | 1" | 6.5" | — | — |
Size in inches, offset and bore in mm. How to read these figures.
Before you buy or fit