
BBS RSII series
BBS RS746
- Size7x17"
- PCD4x114.3
- OffsetET42
- Centre bore73 mm
This page covers the BBS RS746, one wheel from the RS II, the two-piece successor to the original RS. It is a 17-inch wheel, 7 inches wide.
The 4x114.3 bolt pattern of the BBS RS746 is the one used by older Nissan and Mitsubishi; the 73 mm centre bore decides whether you need hub-centric rings.
At ET42 the BBS RS746 has its mounting face well outboard of the centre line, which pulls the wheel inward; that suits front-drive and modern hubs. A 7-inch rim normally takes tyres from about 175 to 225 mm wide.
At 17 inches, the BBS RS746 also has to clear the brake calipers of the car it goes on; that matters most where the brakes have been upgraded.
Note on record: stern.
The fitment of the BBS RS746 is not recorded here; the back of the centre usually carries the offset and part number, so check the wheel itself.
For the history behind the BBS RS746, how to spot a genuine wheel and what to check when buying used, see the BBS RSII series guide.
Specifications
| Model / part | PCD | Diameter (in) | Width (in) | Offset (ET) | Centre bore (mm) | Lip | Barrel | Fitment | Notes |
|---|---|---|---|---|---|---|---|---|---|
| BBS RS746 | 4x114.3 | 17 | 7 | 42 | 73 | — | — | — | stern |
Size in inches, offset and bore in mm. How to read these figures.
Before you buy or fit