BBS RS002 wheel

BBS RS series

BBS RS002

  • Size8x15"
  • PCD4x100
  • OffsetET12
  • Centre bore57 mm
  • Lip2 1/8"
  • Barrel5 3/8"

The BBS RS002 belongs to the RS, a three-piece cross-spoke mesh wheel first sold in the 1980s. It is a 15-inch wheel, 8 inches wide and is listed for BMW 3/1.

The 4x100 bolt pattern of the BBS RS002 is the one used by older BMW, VW, Honda and Mazda; the 57 mm centre bore decides whether you need hub-centric rings.

The BBS RS002 has a low ET12 offset, so the face sits well outboard; that is typical of older rear-drive cars and of wheels meant to fill the arches. Tyre widths of roughly 205-245 mm are the usual match for an 8-inch rim.

At 15 inches, the BBS RS002 also has to clear the brake calipers of the car it goes on; that matters most where the brakes have been upgraded.

Lip and barrel recorded for the BBS RS002: lip 2 1/8", barrel 5 3/8". You need these figures to order replacement rim halves or rebuild the wheel to a new width.

For the history behind the BBS RS002, how to spot a genuine wheel and what to check when buying used, see the BBS RS series guide.

Specifications

BBS RS002 specifications
Model / partPCDDiameter (in)Width (in)Offset (ET)Centre bore (mm)LipBarrelFitmentNotes
BBS RS0024x10015812572 1/8"5 3/8"BMW 3/1—

Size in inches, offset and bore in mm. How to read these figures.

All BBS RS models