
BBS RS series
BBS RS004
- Size8x16"
- PCD4x100
- OffsetET12
- Centre bore57 mm
- Lip2 1/8"
- Barrel5 3/8"
This page covers the BBS RS004, one wheel from the RS range, built from a cast mesh centre bolted between separate inner and outer rim halves. It measures 8x16 inches and is listed for BMW 3/1.
The 4x100 bolt pattern of the BBS RS004 is the one used by older BMW, VW, Honda and Mazda; the 57 mm centre bore decides whether you need hub-centric rings.
The BBS RS004 has a low ET12 offset, so the face sits well outboard; that is typical of older rear-drive cars and of wheels meant to fill the arches. Tyre widths of roughly 205-245 mm are the usual match for an 8-inch rim.
Before fitting a 16-inch BBS RS004, check caliper clearance as well as offset, especially on cars with larger aftermarket brakes.
Lip and barrel recorded for the BBS RS004: lip 2 1/8", barrel 5 3/8". You need these figures to order replacement rim halves or rebuild the wheel to a new width.
Note on record: 15" center.
For the history behind the BBS RS004, how to spot a genuine wheel and what to check when buying used, see the BBS RS series guide.
Specifications
| Model / part | PCD | Diameter (in) | Width (in) | Offset (ET) | Centre bore (mm) | Lip | Barrel | Fitment | Notes |
|---|---|---|---|---|---|---|---|---|---|
| BBS RS004 | 4x100 | 16 | 8 | 12 | 57 | 2 1/8" | 5 3/8" | BMW 3/1 | 15" center |
Size in inches, offset and bore in mm. How to read these figures.
Before you buy or fit