BBS RS058 wheel

BBS RS series

BBS RS058

  • Size10x16"
  • PCD5x112
  • OffsetET11
  • Centre bore66.5 mm
  • Lip3"
  • Barrel6.5"

The BBS RS058 belongs to the RS range, built from a cast mesh centre bolted between separate inner and outer rim halves. It measures 10x16 inches and is listed for MB 107, 123, 126 HA.

The 5x112 bolt pattern of the BBS RS058 is the one used by Audi, VW, Mercedes-Benz and later BMW; the 66.5 mm centre bore decides whether you need hub-centric rings.

The BBS RS058 has a low ET11 offset, so the face sits well outboard; that is typical of older rear-drive cars and of wheels meant to fill the arches. Tyre widths of roughly 255-295 mm are the usual match for a 10-inch rim.

Before fitting a 16-inch BBS RS058, check caliper clearance as well as offset, especially on cars with larger aftermarket brakes.

Lip and barrel recorded for the BBS RS058: lip 3", barrel 6.5". You need these figures to order replacement rim halves or rebuild the wheel to a new width.

More on where the BBS RS058 came from and how it is built is on the BBS RS page.

Specifications

BBS RS058 specifications
Model / partPCDDiameter (in)Width (in)Offset (ET)Centre bore (mm)LipBarrelFitmentNotes
BBS RS0585x11216101166.53"6.5"MB 107, 123, 126 HA—

Size in inches, offset and bore in mm. How to read these figures.

All BBS RS models