BBS RS style illustration
Illustration of the BBS RS design; no photo of this exact part number.

BBS RS series

BBS RS219

  • Size9x16"
  • PCD4x108
  • OffsetET9
  • Centre bore57 mm
  • Lip2.5"
  • Barrel6"

This page covers the BBS RS219, one wheel from the RS range, built from a cast mesh centre bolted between separate inner and outer rim halves. Size is 9J x 16 and is listed for Audi 80, 90 Typ 89.

The 4x108 bolt pattern of the BBS RS219 is the one used by Ford, Peugeot and Citroën; the 57 mm centre bore decides whether you need hub-centric rings.

The BBS RS219 has a low ET9 offset, so the face sits well outboard; that is typical of older rear-drive cars and of wheels meant to fill the arches. Tyre widths of roughly 225-275 mm are the usual match for a 9-inch rim.

Before fitting a 16-inch BBS RS219, check caliper clearance as well as offset, especially on cars with larger aftermarket brakes.

BBS RS219 multi-piece build: lip 2.5", barrel 6". You need these figures to order replacement rim halves or rebuild the wheel to a new width.

More on where the BBS RS219 came from and how it is built is on the BBS RS page.

Specifications

BBS RS219 specifications
Model / partPCDDiameter (in)Width (in)Offset (ET)Centre bore (mm)LipBarrelFitmentNotes
BBS RS2194x1081699572.5"6"Audi 80, 90 Typ 89—

Size in inches, offset and bore in mm. How to read these figures.

All BBS RS models