
BBS RS series
BBS RS258
- Size9.5x17"
- PCD5x130
- OffsetET52
- Centre bore71.6 mm
- Lip1"
- Barrel8"
This page covers the BBS RS258, one wheel from the RS range, built from a cast mesh centre bolted between separate inner and outer rim halves. It is a 17-inch wheel, 9.5 inches wide and is listed for Porsche 964 HA.
On the BBS RS258, the 5x130 PCD is the one used by Porsche and some Mercedes-Benz; the 71.6 mm centre bore matches Porsche hubs.
ET52 is a high offset for the BBS RS258, so it tucks well inside the arch, as front-drive and most modern cars need. Tyre widths of roughly 245-285 mm are the usual match for a 9.5-inch rim.
At 17 inches, the BBS RS258 also has to clear the brake calipers of the car it goes on; that matters most where the brakes have been upgraded.
The BBS RS258 is a multi-piece wheel, so the lip and barrel are separate parts: lip 1", barrel 8". You need these figures to order replacement rim halves or rebuild the wheel to a new width.
More on where the BBS RS258 came from and how it is built is on the BBS RS page.
Specifications
| Model / part | PCD | Diameter (in) | Width (in) | Offset (ET) | Centre bore (mm) | Lip | Barrel | Fitment | Notes |
|---|---|---|---|---|---|---|---|---|---|
| BBS RS258 | 5x130 | 17 | 9.5 | 52 | 71.6 | 1" | 8" | Porsche 964 HA | — |
Size in inches, offset and bore in mm. How to read these figures.
Before you buy or fit