BBS RS style illustration
Illustration of the BBS RS design; no photo of this exact part number.

BBS RS series

BBS RS271

  • Size10x17"
  • PCD5x130
  • OffsetET0
  • Centre bore71.6 mm
  • Lip3.5"
  • Barrel6"

BBS RS271 is a part number from the RS range, built from a cast mesh centre bolted between separate inner and outer rim halves. It is a 17-inch wheel, 10 inches wide and is listed for Porsche 964 HA.

The 5x130 bolt pattern of the BBS RS271 is the one used by Porsche and some Mercedes-Benz; the 71.6 mm centre bore matches Porsche hubs.

The BBS RS271 has a low ET0 offset, so the face sits well outboard; that is typical of older rear-drive cars and of wheels meant to fill the arches. A 10-inch rim normally takes tyres from about 255 to 295 mm wide.

Before fitting a 17-inch BBS RS271, check caliper clearance as well as offset, especially on cars with larger aftermarket brakes.

The BBS RS271 is a multi-piece wheel, so the lip and barrel are separate parts: lip 3.5", barrel 6". You need these figures to order replacement rim halves or rebuild the wheel to a new width.

More on where the BBS RS271 came from and how it is built is on the BBS RS page.

Specifications

BBS RS271 specifications
Model / partPCDDiameter (in)Width (in)Offset (ET)Centre bore (mm)LipBarrelFitmentNotes
BBS RS2715x1301710071.63.5"6"Porsche 964 HA—

Size in inches, offset and bore in mm. How to read these figures.

All BBS RS models