BBS RSII style illustration
Illustration of the BBS RSII design; no photo of this exact part number.

BBS RSII series

BBS RS700

  • Size8.5x18"
  • PCD5x120
  • OffsetET22

This page covers the BBS RS700, one wheel from the RS II, the two-piece successor to the original RS. It measures 8.5x18 inches and is listed for BMW.

The 5x120 bolt pattern of the BBS RS700 is the one used by BMW and some Land Rover and Honda.

An offset of ET22 puts the BBS RS700 in the usual range for European saloons of its era. An 8.5-inch rim normally takes tyres from about 215 to 265 mm wide.

At 18 inches, the BBS RS700 also has to clear the brake calipers of the car it goes on; that matters most where the brakes have been upgraded.

Note on record: concave.

The centre bore of the BBS RS700 is not recorded here; the back of the centre usually carries the offset and part number, so check the wheel itself.

More on where the BBS RS700 came from and how it is built is on the BBS RSII page.

Specifications

BBS RS700 specifications
Model / partPCDDiameter (in)Width (in)Offset (ET)Centre bore (mm)LipBarrelFitmentNotes
BBS RS7005x120188.522———BMWconcave

Size in inches, offset and bore in mm. How to read these figures.

All BBS RSII models