BBS RSII style illustration
Illustration of the BBS RSII design; no photo of this exact part number.

BBS RSII series

BBS RS861

  • Size8.5x19"
  • PCD5x112
  • OffsetET48
  • Centre bore57 mm

BBS RS861 is a part number from the RS II, the two-piece successor to the original RS. It measures 8.5x19 inches and is listed for vag.

The 5x112 bolt pattern of the BBS RS861 is the one used by Audi, VW, Mercedes-Benz and later BMW; the 57 mm centre bore decides whether you need hub-centric rings.

At ET48 the BBS RS861 has its mounting face well outboard of the centre line, which pulls the wheel inward; that suits front-drive and modern hubs. Tyre widths of roughly 215-265 mm are the usual match for an 8.5-inch rim.

At 19 inches, the BBS RS861 also has to clear the brake calipers of the car it goes on; that matters most where the brakes have been upgraded.

More on where the BBS RS861 came from and how it is built is on the BBS RSII page.

Specifications

BBS RS861 specifications
Model / partPCDDiameter (in)Width (in)Offset (ET)Centre bore (mm)LipBarrelFitmentNotes
BBS RS8615x112198.54857——vag—

Size in inches, offset and bore in mm. How to read these figures.

All BBS RSII models