BBS RS style illustration
Illustration of the BBS RS design; no photo of this exact part number.

BBS RS series

BBS RS277

  • Size12x17"
  • PCD5x112
  • OffsetET-45
  • Centre bore66.5 mm
  • Lip6"
  • Barrel6"

The BBS RS277 belongs to the RS range, built from a cast mesh centre bolted between separate inner and outer rim halves. It is a 17-inch wheel, 12 inches wide and is listed for MB 124, 126 HA.

On the BBS RS277, the 5x112 PCD is the one used by Audi, VW, Mercedes-Benz and later BMW; the 66.5 mm centre bore decides whether you need hub-centric rings.

The BBS RS277 has a low ET-45 offset, so the face sits well outboard; that is typical of older rear-drive cars and of wheels meant to fill the arches. Tyre widths of roughly 305-345 mm are the usual match for a 12-inch rim.

At 17 inches, the BBS RS277 also has to clear the brake calipers of the car it goes on; that matters most where the brakes have been upgraded.

Lip and barrel recorded for the BBS RS277: lip 6", barrel 6". You need these figures to order replacement rim halves or rebuild the wheel to a new width.

More on where the BBS RS277 came from and how it is built is on the BBS RS page.

Specifications

BBS RS277 specifications
Model / partPCDDiameter (in)Width (in)Offset (ET)Centre bore (mm)LipBarrelFitmentNotes
BBS RS2775x1121712-4566.56"6"MB 124, 126 HA—

Size in inches, offset and bore in mm. How to read these figures.

All BBS RS models