BBS RS style illustration
Illustration of the BBS RS design; no photo of this exact part number.

BBS RS series

BBS RS286

  • Size9.5x18"
  • PCD5x120
  • OffsetET13
  • Centre bore72.5 mm
  • Lip2.5"
  • Barrel6.5"

This page covers the BBS RS286, one wheel from the RS, a three-piece cross-spoke mesh wheel first sold in the 1980s. Size is 9.5J x 18 and is listed for BMW 5/H, 7/1, evtl.8.

The 5x120 bolt pattern of the BBS RS286 is the one used by BMW and some Land Rover and Honda; the 72.5 mm centre bore matches BMW hubs.

With ET13 on the BBS RS286, the mounting face is close to the centre line, which pushes the wheel out towards the arch lip. A 9.5-inch rim normally takes tyres from about 245 to 285 mm wide.

At 18 inches, the BBS RS286 also has to clear the brake calipers of the car it goes on; that matters most where the brakes have been upgraded.

Lip and barrel recorded for the BBS RS286: lip 2.5", barrel 6.5". You need these figures to order replacement rim halves or rebuild the wheel to a new width.

Note on record: 17" center (doublestep).

More on where the BBS RS286 came from and how it is built is on the BBS RS page.

Specifications

BBS RS286 specifications
Model / partPCDDiameter (in)Width (in)Offset (ET)Centre bore (mm)LipBarrelFitmentNotes
BBS RS2865x120189.51372.52.5"6.5"BMW 5/H, 7/1, evtl.817" center (doublestep)

Size in inches, offset and bore in mm. How to read these figures.

All BBS RS models