BBS RS style illustration
Illustration of the BBS RS design; no photo of this exact part number.

BBS RS series

BBS RS288

  • Size9.5x18"
  • PCD5x112
  • OffsetET13
  • Centre bore72.5 mm
  • Lip2.5"
  • Barrel6.5"

This page covers the BBS RS288, one wheel from the classic three-piece RS family. Size is 9.5J x 18 and is listed for MB 126 HA.

The 5x112 bolt pattern of the BBS RS288 is the one used by Audi, VW, Mercedes-Benz and later BMW; the 72.5 mm centre bore matches BMW hubs.

The BBS RS288 has a low ET13 offset, so the face sits well outboard; that is typical of older rear-drive cars and of wheels meant to fill the arches. Tyre widths of roughly 245-285 mm are the usual match for a 9.5-inch rim.

At 18 inches, the BBS RS288 also has to clear the brake calipers of the car it goes on; that matters most where the brakes have been upgraded.

The BBS RS288 is a multi-piece wheel, so the lip and barrel are separate parts: lip 2.5", barrel 6.5". You need these figures to order replacement rim halves or rebuild the wheel to a new width.

Note on record: 17" center (doublestep).

More on where the BBS RS288 came from and how it is built is on the BBS RS page.

Specifications

BBS RS288 specifications
Model / partPCDDiameter (in)Width (in)Offset (ET)Centre bore (mm)LipBarrelFitmentNotes
BBS RS2885x112189.51372.52.5"6.5"MB 126 HA17" center (doublestep)

Size in inches, offset and bore in mm. How to read these figures.

All BBS RS models