BBS RS style illustration
Illustration of the BBS RS design; no photo of this exact part number.

BBS RS series

BBS RS308

  • Size8x17"
  • PCD5x114.3
  • OffsetET7
  • Centre bore67 mm
  • Lip1.5"
  • Barrel6"

This page covers the BBS RS308, one wheel from the RS range, built from a cast mesh centre bolted between separate inner and outer rim halves. It measures 8x17 inches and is listed for Toyota Crown 3L, 4L.

The 5x114.3 bolt pattern of the BBS RS308 is the one used by many Japanese and Korean cars; the 67 mm centre bore decides whether you need hub-centric rings.

The BBS RS308 has a low ET7 offset, so the face sits well outboard; that is typical of older rear-drive cars and of wheels meant to fill the arches. An 8-inch rim normally takes tyres from about 205 to 245 mm wide.

At 17 inches, the BBS RS308 also has to clear the brake calipers of the car it goes on; that matters most where the brakes have been upgraded.

Lip and barrel recorded for the BBS RS308: lip 1.5", barrel 6". You need these figures to order replacement rim halves or rebuild the wheel to a new width.

For the history behind the BBS RS308, how to spot a genuine wheel and what to check when buying used, see the BBS RS series guide.

Specifications

BBS RS308 specifications
Model / partPCDDiameter (in)Width (in)Offset (ET)Centre bore (mm)LipBarrelFitmentNotes
BBS RS3085x114.31787671.5"6"Toyota Crown 3L, 4L—

Size in inches, offset and bore in mm. How to read these figures.

All BBS RS models