
BBS RS series
BBS RS350
- Size7.5x17"
- PCD5x114.3
- OffsetET40
- Centre bore60 mm
- Lip0.5"
- Barrel6.5"
BBS RS350 is a part number from the RS range, built from a cast mesh centre bolted between separate inner and outer rim halves. Size is 7.5J x 17.
On the BBS RS350, the 5x114.3 PCD is the one used by many Japanese and Korean cars; the 60 mm centre bore decides whether you need hub-centric rings.
ET40 is a high offset for the BBS RS350, so it tucks well inside the arch, as front-drive and most modern cars need. A 7.5-inch rim normally takes tyres from about 195 to 235 mm wide.
At 17 inches, the BBS RS350 also has to clear the brake calipers of the car it goes on; that matters most where the brakes have been upgraded.
Lip and barrel recorded for the BBS RS350: lip 0.5", barrel 6.5". You need these figures to order replacement rim halves or rebuild the wheel to a new width.
The fitment of the BBS RS350 is not recorded here; the back of the centre usually carries the offset and part number, so check the wheel itself.
For the history behind the BBS RS350, how to spot a genuine wheel and what to check when buying used, see the BBS RS series guide.
Specifications
| Model / part | PCD | Diameter (in) | Width (in) | Offset (ET) | Centre bore (mm) | Lip | Barrel | Fitment | Notes |
|---|---|---|---|---|---|---|---|---|---|
| BBS RS350 | 5x114.3 | 17 | 7.5 | 40 | 60 | 0.5" | 6.5" | — | — |
Size in inches, offset and bore in mm. How to read these figures.
Before you buy or fit