
BBS RSII series
BBS RS711
- Size10x18"
- PCD5x112
- OffsetET40
The BBS RS711 belongs to the RS II range, which kept the mesh look of the RS on a two-piece construction. Size is 10J x 18 and is listed for vag.
On the BBS RS711, the 5x112 PCD is the one used by Audi, VW, Mercedes-Benz and later BMW.
At ET40 the BBS RS711 has its mounting face well outboard of the centre line, which pulls the wheel inward; that suits front-drive and modern hubs. A 10-inch rim normally takes tyres from about 255 to 295 mm wide.
At 18 inches, the BBS RS711 also has to clear the brake calipers of the car it goes on; that matters most where the brakes have been upgraded.
No centre bore figure is recorded for the BBS RS711. Read the markings on the back of the wheel before relying on it.
More on where the BBS RS711 came from and how it is built is on the BBS RSII page.
Specifications
| Model / part | PCD | Diameter (in) | Width (in) | Offset (ET) | Centre bore (mm) | Lip | Barrel | Fitment | Notes |
|---|---|---|---|---|---|---|---|---|---|
| BBS RS711 | 5x112 | 18 | 10 | 40 | — | — | — | vag | — |
Size in inches, offset and bore in mm. How to read these figures.
Before you buy or fit