BBS RSII style illustration
Illustration of the BBS RSII design; no photo of this exact part number.

BBS RSII series

BBS RS725

  • Size8x18"
  • PCD5x114.3
  • OffsetET40

The BBS RS725 belongs to the RS II, the two-piece successor to the original RS. It measures 8x18 inches.

On the BBS RS725, the 5x114.3 PCD is the one used by many Japanese and Korean cars.

At ET40 the BBS RS725 has its mounting face well outboard of the centre line, which pulls the wheel inward; that suits front-drive and modern hubs. An 8-inch rim normally takes tyres from about 205 to 245 mm wide.

At 18 inches, the BBS RS725 also has to clear the brake calipers of the car it goes on; that matters most where the brakes have been upgraded.

The centre bore and fitment of the BBS RS725 are not recorded here; the back of the centre usually carries the offset and part number, so check the wheel itself.

More on where the BBS RS725 came from and how it is built is on the BBS RSII page.

Specifications

BBS RS725 specifications
Model / partPCDDiameter (in)Width (in)Offset (ET)Centre bore (mm)LipBarrelFitmentNotes
BBS RS7255x114.318840—————

Size in inches, offset and bore in mm. How to read these figures.

All BBS RSII models