BBS RSII style illustration
Illustration of the BBS RSII design; no photo of this exact part number.

BBS RSII series

BBS RS810

  • Size8x18"
  • PCD5x114.3
  • OffsetET42

The BBS RS810 belongs to the RS II range, which kept the mesh look of the RS on a two-piece construction. It measures 8x18 inches.

On the BBS RS810, the 5x114.3 PCD is the one used by many Japanese and Korean cars.

At ET42 the BBS RS810 has its mounting face well outboard of the centre line, which pulls the wheel inward; that suits front-drive and modern hubs. An 8-inch rim normally takes tyres from about 205 to 245 mm wide.

At 18 inches, the BBS RS810 also has to clear the brake calipers of the car it goes on; that matters most where the brakes have been upgraded.

Note on record: hinodex.

The centre bore and fitment of the BBS RS810 are not recorded here; the back of the centre usually carries the offset and part number, so check the wheel itself.

More on where the BBS RS810 came from and how it is built is on the BBS RSII page.

Specifications

BBS RS810 specifications
Model / partPCDDiameter (in)Width (in)Offset (ET)Centre bore (mm)LipBarrelFitmentNotes
BBS RS8105x114.318842————hinodex

Size in inches, offset and bore in mm. How to read these figures.

All BBS RSII models