
Lesser-known cast line
BBS CO wheels
The CO is a BBS cast road wheel that appears in used listings without much supporting detail. This page explains what the markings on a BBS cast wheel mean and how to use them to decide if a set suits your car.
- Construction
- One-piece cast aluminium (C-series)
- Documentation
- Limited; specs not confirmed here
- Maker
- BBS
Limits of what we can tell you
The CO is part of BBS's cast range, but we have not found reliable data on its launch, sizes or the cars it was mainly sold for. Several BBS cast designs were short-lived or regional, and model names alone can mislead. We keep the facts box minimal for that reason. The rest of the page applies to any BBS one-piece cast wheel, the CO included.
Approval markings and paperwork
Aftermarket wheels sold in Germany need approval, and BBS wheels for that market typically carry a KBA number on the casting. In practice this ties the wheel to a type approval or report listing which cars and tyre sizes it is cleared for. Other countries handle this differently, and some have no equivalent rule. If you live somewhere with wheel approval requirements, having the right paperwork can matter for inspections and insurance. Ask the seller if they still have it. If not, the approval number on the wheel may let you trace it.
Load rating
Every road wheel is designed for a maximum load. A wheel rated for a small hatchback may not be suitable for a heavy SUV or estate with the same bolt pattern. Some BBS wheels show the load rating on the casting, and approval documents list it too. Compare it with your car's axle weights from the handbook or VIN plate: divide the heavier axle figure by two to get the minimum load per wheel. If you cannot find a load rating, be cautious about fitting the wheels to a heavy car.
Fitting and torque
Clean the hub face and the back of the wheel, check the bolt seat type matches the bolts, and fit hub rings if the bore is larger than the hub. Start each bolt by hand, snug them in a star pattern, lower the car and torque to the figure the car maker gives. Check torque again after a short drive. These steps prevent most of the problems people blame on the wheel itself, such as vibration or loose bolts.
Seven-spoke and multi-spoke cleaning
Whatever the exact design, cast BBS wheels with several spokes are easiest to clean with a long, soft brush that reaches the inner barrel through the spoke gaps. Rinse first to lift loose grit, apply a non-acid cleaner, agitate and rinse again. Dry the wheel so minerals in the water do not mark the finish. A sealant every few months makes later washes quicker. More in caring for BBS wheels.
Before you buy
Ask for photos of the markings on each wheel, confirm the sizes match each other, and check for bends and cracks. For a lesser-known model, also ask whether caps and hub rings are included, since sourcing them later takes time. The used buying guide has a full checklist.
Spare wheels and punctures
A full-size spare that matches an aftermarket set is unusual, so most owners rely on the car's original space-saver, a repair kit or run-flat tyres. Check that your space-saver still clears the brakes and that you carry the right bolts for it, since factory and aftermarket bolts are not always the same length. If you carry a locking-bolt key, keep it with the jack. A puncture on a dark road is not the time to discover a missing key or the wrong bolts for the spare.
Frequently asked questions
What is a KBA number on a BBS wheel?
It refers to German type approval. It links the wheel to documentation listing the cars and tyre sizes it is approved for.
How do I check the load rating?
Look for it on the casting or in the approval paperwork, and compare with half your car's heavier axle weight.
Is the CO a forged wheel?
No. It belongs to the BBS cast one-piece range.
Do I need the original paperwork?
Only in countries that require wheel approval documents. Elsewhere it is useful but not needed.